The Vaporesso EUC 1.0 ohm Coils are made from Clapton wire and organic japanese cotton. The EUC 1.0 ohm coils are reccomended to be used between 10w-14w, and should be used for a MTL (Mouth to Lung) inhales as it will have a tigher draw. These coils are extrememly easy to install and replace, making them a great options for new or experienced vapors.
1 x Pack of Replaceable EUC 1.0ohm Coils 10W-14W (5pcs/pkg)
Important: Priming your coils is one of the most important steps before using a new tank/clearomizer and a new coil/atomizer. Priming your coil ensures you won't burn your coil before taking a hit. It also makes sure that the coil lasts as long as possible. For Ceramic Coils the process is very similar however they require a longer to saturate before you take your first puff.
Step 1. Drop e-liquid in the center of the coil ensuring the juice is soaked up by the cotton and let it slide down so it hits the wire. Repeat this process on the wick holes on the side of the coil. The juice will soak the cotton and this will ensure that you won't experience a dry hit.
Step 2. Attach your tank and fill with e-liquid then leave it to stand for a 20-30 minutes, so that the juice in the tank gets soaked up by the coil/atomizer too.
Step 3. After you have primed the coil and let it sit for a few minutes you should fire your device below the recommended wattage and slowly increase in smaller intervals to ensure your atomizer does not burn out right away. It's recommended that you don't fire your device at maximum recommended wattage until you've puffed on it approximately 10 times.
|Coil OHM||1.0 OHM|
|Coil/Wire Type||Ceramic, Stainless Steel (SS316)|
|Compatible Tank||Vaporesso VM Tank|
|Draw Type||Mouth To Lung (MTL)|